Charlieplexing Article

This is the place for any magazine-related discussions that don't fit in any of the column discussion boards below.
Post Reply
xzolian
Posts: 2
Joined: Sun Dec 09, 2007 9:16 am
Contact:

Charlieplexing Article

Post by xzolian » Sun Dec 09, 2007 9:18 am

Within the last year I read an article in either Servo or Nuts and Volts about charlieplexing but now I can't seem to find it to save my life. I tried searching for it but I came up with nothing.

Does anyone know what issue it was in?

User avatar
jaem
Posts: 148
Joined: Thu Feb 15, 2007 3:36 pm
Location: BC, Canada
Contact:

Post by jaem » Sun Dec 09, 2007 9:57 am

I remember that too - I have the issue somewhere... I can't remember where it is either, but if no one's found it by the time my two exams are through, I'll take a look for you.
(sorry, but I'm a bit busy studying...:P)

xzolian
Posts: 2
Joined: Sun Dec 09, 2007 9:16 am
Contact:

Post by xzolian » Mon Dec 10, 2007 3:58 pm

jaem wrote:I remember that too - I have the issue somewhere... I can't remember where it is either, but if no one's found it by the time my two exams are through, I'll take a look for you.
(sorry, but I'm a bit busy studying...:P)
I would appreciate it :)

No need to do it now, after you exams is fine.

-Matt

User avatar
haklesup
Posts: 2945
Joined: Thu Aug 01, 2002 1:01 am
Location: San Jose CA
Contact:

Post by haklesup » Mon Dec 10, 2007 4:36 pm

Charlieplexing sounds like something that belonged in the April Fools column but googling it shows that it is legitamate and created by a guy at Maxim hence the Maxim AppNote attached


http://www.maxim-ic.com/appnotes.cfm/an_pk/1880

I searched N&V articals for LED and August 2006 has something on multiplexing but might not be the article you were looking for. Was it an article or a mention in a letter or column, do you remember.

User avatar
jaem
Posts: 148
Joined: Thu Feb 15, 2007 3:36 pm
Location: BC, Canada
Contact:

Post by jaem » Mon Dec 10, 2007 6:04 pm

I think I looked up that Maxim article after I saw it in the magazine - I can't remember, but it may have been referenced in the article. I don't know if that will help, though...

User avatar
rebeltaz
Posts: 18
Joined: Wed Dec 26, 2007 1:43 pm
Contact:

Post by rebeltaz » Wed Dec 26, 2007 1:45 pm


Post Reply

Who is online

Users browsing this forum: No registered users and 13 guests