Page 1 of 1

About that CNC question...

Posted: Wed Oct 21, 2009 4:28 pm
by CeaSaR
I was looking around the web today and found this page on an open source CNC project. I know that
a number of members have expressed interest in homemade machining devices and I wanted to share
my find with you. I would have posted it on the individual thread, but I could not find the one I was
looking for. By the way, the guy who I told I would find my copy of Popular Electronics that had the
XYZ table project in it, I haven't been able to locate that magazine. Hopefully, this article will help all
of those that I tried to help in the past.

Happy machining!

CeaSaR