Standard IF frequencies

This is the place for any magazine-related discussions that don't fit in any of the column discussion boards below.
Post Reply
User avatar
Posts: 1289
Joined: Thu Jan 03, 2002 1:01 am
Location: Northern Illinois

Standard IF frequencies

Post by jollyrgr » Sun Sep 11, 2005 2:23 am

Does someone have a source (or know) what the standard IF frequencies are? I know AM radios normally use 455kHz, FM radios 10.7MHz, some scanners 10.8MHz, and some CBs used (I believe) 7.8MHz. In satellite systems they use 5150 MHz and 10750 MHz as the IF for the C and Ku LNBs. Cable TV "head end" systems use a 70MHz IF for a loop out.<p>What are some that I am missing?
No trees were harmed in the creation of this message. But billions of electrons, photons, and electromagnetic waves were terribly inconvenienced!

Robert Reed
Posts: 2276
Joined: Wed Nov 24, 2004 1:01 am

Re: Standard IF frequencies

Post by Robert Reed » Sun Sep 11, 2005 9:45 am

Older car radios used 262Khz, Analogue televisions used 45Mhz. All the trunked 800 Mhz systems I have seen also use 45Mhz (first conversion). Radar uses 70 Mhz. However any well designed narrow band trancievers base their conversions and subsequent IF frequencys on many aspects of their particular operating bands (image rejection being only one of many things to consider). I have seen IF frequencies from 150 Khz to 70 Mhz depending on type of use.
But I think you have covered 99% of consumer electronics with 455K & 10.7M.(radio products).

Posts: 404
Joined: Sun Nov 07, 2004 1:01 am
Location: colorado

Re: Standard IF frequencies

Post by terri » Tue Sep 13, 2005 1:53 am

Some old 1940-1950 TV sets used a 14MHz first conversion IF and it was big problem since it sat smack in the middle of the 20 Meter ham band. So every time a ham keyed up, it played hob with TV reception for owners of that brand. Of course, it was always the ham's fault, not the bonehead who chose this f for an IF.<p>Over the years, that brand of TV set fell into disrepute, probably because of the constant TVI (TeleVision Interference) issues, so the problem finally evaporated. <p>Just goes to show you. Choose your IF with care.<p>[ September 13, 2005: Message edited by: terri ]</p>
terri wd0edw

Posts: 98
Joined: Tue Apr 19, 2005 1:01 am

Re: Standard IF frequencies

Post by ezpcb » Tue Sep 13, 2005 7:00 am

Old receivers use 200kHz because they use mechanical filter for the IF.<p>465k is also widely used in asia MW radio.<p>many dual convertion shortwave receivers use 58.245M and 455k(465k) as 1st and 2nd IF.
High Quality PCB for Electronics Hobbists, Pay for Chrokee, Get Land Rover

Post Reply

Who is online

Users browsing this forum: No registered users and 25 guests