I need a 750 ohm, 1% or 5% Tolerance, 1/2Watt Resistor to finish a Isolated 9V DC Supply.
Will trade for, or purchase out right.
Signed: Janitor tzap
Wanted: 750 ohm, 1% or 5% Tolerance, 1/2Watt...............
- Janitor Tzap
- Posts: 1737
- Joined: Sat Aug 12, 2006 5:17 pm
- Contact:
- dacflyer
- Posts: 4772
- Joined: Fri Feb 08, 2002 1:01 am
- Location: USA / North Carolina / Fayetteville
- Contact:
Re: Wanted: 750 ohm, 1% or 5% Tolerance, 1/2Watt............
have you not tried to combine more than 1 resistor to get the value you need ?
such as a 560 + 190 = 750
or use a small trim pot like a 1K and adjust it down to 750.
such as a 560 + 190 = 750
or use a small trim pot like a 1K and adjust it down to 750.
-
- Posts: 1937
- Joined: Fri Aug 22, 2003 1:01 am
- Location: Izmir, Turkiye; from Rochester, NY
- Contact:
Re: Wanted: 750 ohm, 1% or 5% Tolerance, 1/2Watt............
Make that a 1W pot if can't find a fixed 750 Ohm 1/2W because full length of resistive material inside the pot is not being used to dispate heat. Better yet a 2W pot because of current that will be flowing through the slider contact.
Dale Y
- dacflyer
- Posts: 4772
- Joined: Fri Feb 08, 2002 1:01 am
- Location: USA / North Carolina / Fayetteville
- Contact:
Re: Wanted: 750 ohm, 1% or 5% Tolerance, 1/2Watt............
ok,, good luck
- Janitor Tzap
- Posts: 1737
- Joined: Sat Aug 12, 2006 5:17 pm
- Contact:
Re: Wanted: 750 ohm, 1% or 5% Tolerance, 1/2Watt............
Thanks for the replies.
750 ohm resistors have been found.
Signed: Janitor Tzap
750 ohm resistors have been found.
Signed: Janitor Tzap
Who is online
Users browsing this forum: No registered users and 0 guests