tricky dc voltage problem
tricky dc voltage problem
I am after a circuit or some kind of IC which takes a low current 5V input and coverts it to 0V, the tricky part is I need the coversion done in real time and the coversion has to work for the entire 0-5V range, i.e. if the input voltage is 4.5 volts then the output is .5 if it's 4V then the output is 1V. So as the input voltage decreases the output voltage increases and vice versa.<p>Your help with this problem is most appreciated.
Re: tricky dc voltage problem
An Op-Amp could do this using the inverting input. Or were you thinking of using an ADC chip or uP?<p>bodgy
On a clear disk you can seek forever.
-
- Posts: 16
- Joined: Mon Mar 25, 2002 1:01 am
- Location: San Jose, CA
- Contact:
Re: tricky dc voltage problem
No. An op-amp wouldn't work because of clipping.
A very stable voltage reference for the
output voltage would be a reverse-biased Zener
diode. You could then use a potentiometer (as
a voltage diver) to reduce it to the desired
voltage.
A very stable voltage reference for the
output voltage would be a reverse-biased Zener
diode. You could then use a potentiometer (as
a voltage diver) to reduce it to the desired
voltage.
Re: tricky dc voltage problem
a reverse-biased Zener diode.This sounds both interesting and promising. Can you please provide more info!
Re: tricky dc voltage problem
Go to http://www.poptronics.com/forums/electronic_bench/ and see the post entitled "Invert and Level Shift". A simplified schematic is posted there.<p>Ron H
Re: tricky dc voltage problem
Thank alot RonH, I have posted some questions about the schematic on the poptronics forum, I hope you get time to answer them.<p>Your help has been greatly appreciated, and if the proposed circuit works, I might show my appreciation in a more tangible manner.<p>Thanks Heaps.
-
- Posts: 1263
- Joined: Wed Dec 05, 2001 1:01 am
- Location: Harviell, MO (Poplar Bluff area)
- Contact:
Re: tricky dc voltage problem
Nearly that exact application came up as a question in the "Q & A" column in Poptronics magazine, June 2001, page 44. The guy was wanting to interface a MAP sensor and needed the phase inversion. We used an Analog Devices AD8541 op amp, which is a rail-to-rail device. A general purpose op amp such as a 741 just won't work because it'll go nonlinear near the end points and will clip too early. Ron's schematic is similar. I'll post the skem on the same thread where Ron posted his. They're similar except that I've included the reference circuitry for the level shifting.<p>Dean
Dean Huster, Electronics Curmudgeon
Contributing Editor emeritus, "Q & A", of the former "Poptronics" magazine (formerly "Popular Electronics" and "Electronics Now" magazines).
R.I.P.
Contributing Editor emeritus, "Q & A", of the former "Poptronics" magazine (formerly "Popular Electronics" and "Electronics Now" magazines).
R.I.P.
Re: tricky dc voltage problem
What you describe is exactly what I am trying to do.<p>Thanks heaps for the info.
Who is online
Users browsing this forum: Majestic-12 [Bot] and 49 guests