no it took less than a day i kind of was busy
and im still looking for parts
What should i do to start building a robot?
- compwiz575
- Posts: 44
- Joined: Fri Jun 09, 2006 12:34 pm
- Contact:
thats what I'm talking about!!!!!!
Looks great!!
You said you went with servos... how do you plan to hook them up... straight to the shaft?? or have a gear tran..
heres a robot that I made a while ago..
http://www.sambuchi.net/Projects/MSP430/Robot/IEEE.htm
but here is a good picture how I hooked up my servos
http://www.sambuchi.net/Projects/MSP430 ... /pic13.JPG
you can always do the gears later If you need more speed or torque.
You may find that the back wheel my change your direction when making turns or even going straight. You might want to sub out the back wheel for a slidder.. also used to slid heavy TV's or furniture around in a house. I put one on my robot if you dont know what I'm talking about...
Looks great! Save room for that power supply!!
Looks great!!
You said you went with servos... how do you plan to hook them up... straight to the shaft?? or have a gear tran..
heres a robot that I made a while ago..
http://www.sambuchi.net/Projects/MSP430/Robot/IEEE.htm
but here is a good picture how I hooked up my servos
http://www.sambuchi.net/Projects/MSP430 ... /pic13.JPG
you can always do the gears later If you need more speed or torque.
You may find that the back wheel my change your direction when making turns or even going straight. You might want to sub out the back wheel for a slidder.. also used to slid heavy TV's or furniture around in a house. I put one on my robot if you dont know what I'm talking about...
Looks great! Save room for that power supply!!
- compwiz575
- Posts: 44
- Joined: Fri Jun 09, 2006 12:34 pm
- Contact:
directly to the shaft
in the pics you can kinda see if you look hard that there already conected
im using ir sensors and im thinking of using bumper sensors for what they miss
the robots great it can already turn corners and navigate around big obstacles
it navigated succefully between my cocktale table and couch
PS: the power suply is a 4 pack of AA's its now stuck to the first level
in the pics you can kinda see if you look hard that there already conected
im using ir sensors and im thinking of using bumper sensors for what they miss
the robots great it can already turn corners and navigate around big obstacles
it navigated succefully between my cocktale table and couch
PS: the power suply is a 4 pack of AA's its now stuck to the first level
ok.. i see the servo mounts that you are using.. I used the same on my robot.. think mine were blue.
there's a lot you can try now.. line following is easy to do.. or put some shaft encoders on it and do some dead reckoning.. Keep a history of this robot and the robots to come... you will be surprised how much you will use it as a reference.
there's a lot you can try now.. line following is easy to do.. or put some shaft encoders on it and do some dead reckoning.. Keep a history of this robot and the robots to come... you will be surprised how much you will use it as a reference.
drooping voltage
u can use regulator 7805 to drop the voltage from 18V to 5V....also from 9V TO 5 V .... the regulator ic 7805 has 3 pins>> link first pin to +18V OR +9V then link second pin to ground(-) last pin gives +5V u want
Who is online
Users browsing this forum: No registered users and 0 guests