PIC's for stepper motor drive.
-
- Posts: 7
- Joined: Tue May 06, 2003 1:01 am
- Location: Bellingham, WA.
- Contact:
PIC's for stepper motor drive.
Being new to Programming, I am wondering if a Pic 16F84 is adequate for operating a stepper motor? The 18C452 chip which Microchip reccomends, is a monster, and far more than I would think would be required. I have the Picstart Plus programmer that Microchip sells, but the complications involved in building a PC board to carry that chip and operate the motor, seems like a lot more than necessary for my little project. Anyone? Thank you. Bert Russell.
Re: PIC's for stepper motor drive.
yes it would be, though I'd recommend getting a more recent Pic (if you need to buy one) such as the 628, 630 819 series. These all have a PWM module making it easier to drive your steppers, but so long as you can write the code the 84 will do fine.<p>Have a look at the code on the square-1 book site, though naturally as they would prefer you to buy their book, the code can be a bit difficult to decipher if you're new to Pics.<p>Colin
On a clear disk you can seek forever.
Who is online
Users browsing this forum: No registered users and 14 guests