HI
Can anybody help me find a drawing for a unipolar stepper motor controller for a pc,I need something simple that i can start off with this is a new project for the shop over the winter.I would like a 3-axis controller for a small mill i have in the shop,even a kit would be ok or and old controller that somebody has to sell cheap....
les
[email protected]
stepper motor controller for pc cnc
Re: stepper motor controller for pc cnc
I built mine from plans by kleinbauer.com
-
- Posts: 184
- Joined: Sun Feb 23, 2003 1:01 am
- Location: Toronto
- Contact:
Re: stepper motor controller for pc cnc
Your could check out this website:<p>http://www.luberth.com/plotter/plotter.htm<p>In the lefthand frame there is a schematic, click on<p>"More amperes, use TIP transistors..."<p>A pcb layout is available under this. This is an extremely simple circuit - a connection to the parallel port of the computer, and 1k resistors to the bases of the TIP120 transistors. That's all you need, except software for the computer. This will drive 3 axes. Simple software examples are avilable on that site.<p>Good luck,
Grant
Grant
Grant
Who is online
Users browsing this forum: No registered users and 39 guests