solder past dispensers
-
- Posts: 38
- Joined: Tue Jun 01, 2004 1:01 am
- Location: Deep 13
- Contact:
solder past dispensers
Does anyone have a solder paste dispensor setup in their lab? I just wanted to see what other people were working with - especially their source for compressed air for the dispenser.
Why don't you give yourself a nice big round of applause!
- Chris Smith
- Posts: 4325
- Joined: Tue Dec 04, 2001 1:01 am
- Location: Bieber Ca.
Re: solder past dispensers
One good tool is the hypos that are used with ink refill kits. Other than that a acid brush and tin can that can be rewarmed and melted back into a clean paste when the debris floats to the top for scraping off to keep it clean.
Re: solder past dispensers
I originally had a commercial dispenser system but went to the prefilled paste syringes with a plunger and plastic tip. I found the hand method easier to control than the pressurized system. The auto dispenser systems can make quite a mess if you are not very careful( the manual ones can too for that matter ) Contact-East has 35 gm syringe bodies of Kester paste for about $10.00. The plunger and tip are each 1.00.
Who is online
Users browsing this forum: No registered users and 140 guests