I ordered the Voice Changer kit from the May 2008 article. The article, parts list and schematic do not give the value for C11. I think (but am not sure) that it is a cap used to reduce noise. Any idea what value I should use?
Adam
Voice Changer (May 2008) - Value for C11?
Re: Voice Changer (May 2008) - Value for C11?
Hi Adam,
I went to the N&V store page and looked at the Voice Changer kit. There is a picture of the PCB and C11 is marked as a 100uF cap. That should get you going!
Regards,
Michael
I went to the N&V store page and looked at the Voice Changer kit. There is a picture of the PCB and C11 is marked as a 100uF cap. That should get you going!
Regards,
Michael
Who is online
Users browsing this forum: No registered users and 10 guests