electric fence made from a microwave transformer.

Get help with your Nuts & Volts projects or Kits purchased from Nuts & Volts here.
Post Reply
indios
Posts: 1
Joined: Fri May 17, 2019 12:19 pm
Contact:

electric fence made from a microwave transformer.

Post by indios » Thu May 28, 2020 10:25 am

I'm thinking of making electric fence charger from an old microwave trans former, I need some ideas, the black bears are getting to bold to get into my beeyard. thanks.

User avatar
Lenp
Posts: 1434
Joined: Thu Oct 26, 2006 8:11 pm
Location: Maryland
Contact:

Re: electric fence made from a microwave transformer.

Post by Lenp » Tue Jun 02, 2020 2:32 pm

There's more to a fence charger than a simple transformer. Before going into this, look at and understand, fence charger specs and the voltage and current. They also pulse the output.
If you are in a shooter friendly area, make a device that fires powder-only shotgun shells at different intervals like is used to scare away birds near airports.
BTW:
A center primed round can be fired with high current going through the primer...
Military aircraft used that method to time the rounds more precisely.

Sure glad I don't underwrite your homeowner's insurance....:???:
Len

“To invent, you need a good imagination and a big pile of junk.” (T. Edison)
"I must be on the way to success since I already have the junk". (Me)

User avatar
dacflyer
Posts: 4506
Joined: Fri Feb 08, 2002 1:01 am
Location: USA / North Carolina / Fayetteville
Contact:

Re: electric fence made from a microwave transformer.

Post by dacflyer » Wed Jun 03, 2020 7:24 pm

Microwave transformers are very lethal and once they draw an arc, they will consume very high current and trip a breaker and most likely set things on fire.. you want something that is low current, and lower voltage.
If you are too cheap to buy a fence charger, and want to build your own, use something safer than a MOT. Perhaps a Ignition coil from a car, you'd have to build a driver circuit. I seen an old antique unit long ago, it used a 6v car battery, It had a slightly off balance beam inside. the heavy side would drift down and hit a contact, and then it would activate a coil to pull the beam back up, and that would fire the coil..it did this about every second or so.
and the coil inside was a ignition coil. the whole set up would run for months on a 6v tractor battery.
Another thing you have to consider, if the birds land on a wire, they won't be effected unless they touch Ground.
birds sit on power lines all day..

Post Reply

Who is online

Users browsing this forum: Majestic-12 [Bot] and 1 guest