![Sad :sad:](./images/smilies/icon_sad.gif)
Hi!
Love your articles on Ardunio.
I did all the Labs 1,2,&3.
Lab 3 however did not do so while.
I used a Laptop to do the labs,
Setting an angle on a servomotor did not do go.
At first it went to 180 degrees, then I typed several degrees points such as 45,90,180. and so on,
from the serial monitor screen I could see the numbers entered, but that's all I was able to see.
the servo did not move. I tested it with a servo sweep test and it worked good.
Labs 1 and 2 was on sending and receiving text and numbers, but lab 3 failed to do that. Why?
It just happen that my Laptop went bad on me, so I did the same test on my desktop computer.
So now Lab 3 will not work because it will not compile the code, and I know for a fact that the code is good.
Sorry for being so wordy.
Can you tell me what happening?
Thanks
Frank G.