S-video to composite converter (Y/C summation)

This is the place for any magazine-related discussions that don't fit in any of the column discussion boards below.
Post Reply
Nil Einne
Posts: 1
Joined: Fri May 24, 2002 1:01 am
Contact:

S-video to composite converter (Y/C summation)

Post by Nil Einne » Fri May 24, 2002 7:33 am

Hi,<p>Does anyone know what issue the S-video to composite converter, i.e. Y/C summation circuit suggestion was in?<p>Thanks all.

User avatar
Chris Smith
Posts: 4325
Joined: Tue Dec 04, 2001 1:01 am
Location: Bieber Ca.

Re: S-video to composite converter (Y/C summation)

Post by Chris Smith » Fri May 24, 2002 1:15 pm

Im not sure if they use a phase difference in the format, but if they don't, Use 914 diodes to seperate up stream and combine down stream the signals.... and Pots on each output leg to find and adjust the individual voltage level/ signals to RE combine all three levels into one. <p>At one volt P to P , the pot value might be in the one meg range? Experiment? You'll know if you get it right if you can cut out a single value like the red/green/blue. <p>Disregard if they use a phase timing or a difference between channels?

User avatar
Externet
Posts: 1861
Joined: Fri Feb 01, 2002 1:01 am
Location: Mideast USA
Contact:

Re: S-video to composite converter (Y/C summation)

Post by Externet » Fri May 24, 2002 9:37 pm

Hello Nil.
Visit this place:<p>http://www.hut.fi/Misc/Electronics/circ ... video.html<p>Enjoy,
Miguel
- Abolish the deciBel ! -

Post Reply

Who is online

Users browsing this forum: No registered users and 40 guests