Page 1 of 1
Looking For X/Y Table Plans
Posted: Mon Nov 24, 2008 10:03 am
by CanYouC3D
Hi All
I'm looking for low cost X/Y Table Plans with a 6" to 12" drive.
Thank's
Chris N.
EMail:
[email protected]
Re: Looking For X/Y Table Plans
Posted: Mon Nov 24, 2008 10:32 am
by VernGraner
CanYouC3D wrote:I'm looking for low cost X/Y Table Plans with a 6" to 12" drive.
At the very low-end there's this:
X/Y Table built from CD/DVD drive mechnisms
A step up would be this:
Roll your Own CNC
And, of course, my personal favorite would be this 3-axis system from Probotix:
Probotix Fireball v90 CNC router kit
Hope that helps!
Vern
Posted: Mon Nov 24, 2008 4:40 pm
by Engineer1138
Checkout cnczone.com there are a lot of plans floating around for everything from building with hardware store parts to ground shaft and bearings.