Hello all...
I am doing a small design that needs a small alpha display.
4 chars wide would be nice.
.75" wide and .375" tall.
5volts or less
dont care what type of interface is needed.
THANKS!
Tony
Small Displays
Re: Small Displays
By far the easiest solution is an "Intelliegent Display"Sambuchi wrote: I am doing a small design that needs a small alpha display.
4 chars wide would be nice.
.75" wide and .375" tall.
5volts or less
dont care what type of interface is needed.
from Osram/Siemens/Avago. I've played with several
surplus ones from eBay, after finding the first two
unmarked pieces at the local electronics fleamarket
(and sitting on them for two years trying to find a
correct datasheet).
The HDLO-2416are available from Digikey for real money
Re: Small Displays
Here's a quick PIX of the first two Intelligent Displays that ISambuchi wrote: I am doing a small design that needs a small alpha display.
got running (2004), using an Atmel Attiny 2313. These are 4
digit 10mm. Other sizes and colours are available.
Hello Bigglez.
I was looking at a very similar part from Osram.. HDSP2000LP
I was not able to find a location to purchase it thou.
The part you mentioned is great and what I am looking for...
It is kinda wider then my design requirements.
The parts you have in your stock pile... are they smaller?
willing to be purchased? I only need 2 at most.
Thanks for the input and if all else fails I will be getting the
digikey part mentioned.
Tony
I was looking at a very similar part from Osram.. HDSP2000LP
I was not able to find a location to purchase it thou.
The part you mentioned is great and what I am looking for...
It is kinda wider then my design requirements.
The parts you have in your stock pile... are they smaller?
willing to be purchased? I only need 2 at most.
Thanks for the input and if all else fails I will be getting the
digikey part mentioned.
Tony
Before hitting Digikey try eBay. I found them a couple ofSambuchi wrote: I was looking at a very similar part from Osram.. HDSP2000LP
I was not able to find a location to purchase it thou.
The part you mentioned is great and what I am looking for...
It is kinda wider then my design requirements.
Thanks for the input and if all else fails I will be getting the
digikey part mentioned.
times. The last purchase I made was a BIN auction.
I did a "make an offer" for about half the eBay list price,
and got ten pieces. They are physically smaller than
the green ones I posted earlier. Perhaps five mm high LEDs?
Who is online
Users browsing this forum: No registered users and 166 guests