BY224 cross ref

This is the place for any magazine-related discussions that don't fit in any of the column discussion boards below.
Post Reply
psycho
Posts: 388
Joined: Thu Jan 10, 2008 8:13 pm
Location: Northwest Indiana
Contact:

BY224 cross ref

Post by psycho »

Hi all,
I need to replace the bridge rectifier in an amp and I can't find a cross ref for it. It's a Philips BY224 - all I found was 4.8A/220V DO-4 pkg. Anyone know of a substitute?

Thanks,
Kevin
Bigglez
Posts: 1282
Joined: Mon Oct 15, 2007 7:39 pm
Contact:

Re: BY224 cross ref

Post by Bigglez »

Greetings Kevin,
psycho wrote:I need to replace the bridge rectifier in an amp and I can't find a cross ref for it. It's a Philips BY224 - all I found was 4.8A/220V DO-4 pkg. Anyone know of a substitute?
That's an old device, but you can easily replace it
with either four diodes or a similar bridge, which will
require that you fashion connecting wires unless you
find an exact physical match.

The easy solution is to use four separate diodes,
like these.

Here's a suitable bridge (may not be physically
the same)

Here's the datasheet. The part number you have is
incomplete, you need to add the PIV rating to the
part number. (Try BY224-600).

If this part is defective there are probably other parts
that caused it to fail. Either do some more testing or
buy more than one replacement...

Comments Welcome!
psycho
Posts: 388
Joined: Thu Jan 10, 2008 8:13 pm
Location: Northwest Indiana
Contact:

Post by psycho »

Hiya bigglez,

Oh, I know there are more components blown. It's in the SMPS for an amp that I inadvertantly pumped 220 into :x ... I have to crawl through every component and see if they are good or bad. The PWM ctrlr I will replace, along w/ 2 2n4401's and the fuse, MOV, blah blah blah... Lost a few traces, too.

If your interested, its a Gallien-Krueger 2100CEL Guitar amp. circa 1988

Kevin
Post Reply

Who is online

Users browsing this forum: No registered users and 16 guests