can a PICAXE-08 be used as a oscillator

This is the place for any magazine-related discussions that don't fit in any of the column discussion boards below.
Post Reply
User avatar
Craig Kendrick Sellen
Posts: 32
Joined: Thu Jan 25, 2007 1:01 am
Location: Carbondale Pennsylvania USA
Contact:

can a PICAXE-08 be used as a oscillator

Post by Craig Kendrick Sellen » Thu Jan 25, 2007 1:18 am

open to all;
can a PICAXE-08 be used as a oscillator? nodout it probly puts out square waves but i want sign waves so probly a LC or a RC network probly has to be on the output. I want it to give sign waves, so a high-pass filter probly has to be added. I want it to put out ether 400Hz or 1KHz, or both?
can this be done? :smile: :grin:
http://www.msnusers.com/103pennywhistler

Michael J
Posts: 55
Joined: Sat Apr 09, 2005 1:01 am
Location: Australia
Contact:

Post by Michael J » Thu Jan 25, 2007 4:51 pm

A complete set of â„¢Picaxe Code, examples and uses can be found in
a PDF document called "picaxe_manual2.pdf " it can be downloaded
from the Rev-Ed website < www.picaxe.co.uk >, try page: 57.

"PWM" can be used on the 08 and 08M chips (I/O Pin-2 / Leg-5).

Your application is fairly slow, you could try making any OP pin
High - pause then Low - pause to get the desired frequency you need.
(You will need the Res/Cap network for a Sine wave output)

"PWMOUT" can be used on the 08M (I/O Pin-2 / Leg-5), see the data
sheet for the larger â„¢Picaxe family chips, e.g. 18X, 28X, 40X.
PWMOUT frequencies start at 4,000Hz to 2,000,000Hz, a neat PWMOUT calculator has been designed and can be found here-
< http://www.fowkc.com/elec/pwmout.shtml >

A simple 08M Test Tone Oscillator of mine using the above calculator
can be found here -
< http://www.porepunkahps.vic.edu.au/home ... llator.htm >
User can select one of 7 tones using a single button.

Some other files here -
< http://www.porepunkahps.vic.edu.au/home ... s/display/ >

Good luck -

Post Reply

Who is online

Users browsing this forum: Google [Bot] and 29 guests