Tweeters

This is the place for any magazine-related discussions that don't fit in any of the column discussion boards below.
Post Reply
myp71
Posts: 585
Joined: Wed Apr 23, 2003 1:01 am
Location: Colorado
Contact:

Tweeters

Post by myp71 » Sun Aug 27, 2006 9:42 pm

I have a couple of tweeters in my car and they are loud and really clear.Any idea what resistior I could put in series, to help reduce the sound and balance out for my mids?


Thanks Ryan

User avatar
haklesup
Posts: 2978
Joined: Thu Aug 01, 2002 1:01 am
Location: San Jose CA
Contact:

Post by haklesup » Mon Aug 28, 2006 11:24 am

It depends on how its wired now. If it is just wired in parallel with the other speaker, then you need a capacitor in series to remove the lower frequencies. Not sure of the value though, 4.7u/50V might be a place to start, the actual value determines the cutoff frequency. Usually use non polarized electrolytics, though have seen smaller value ceramic caps in some piezo speakers. All mine came with the speakers and I haven't looked in quite a while.

As for a resistor, it would help to know the impedance of the tweeter. If its a paper cone then it might be 4, 8 or 16 ohms but if its piezoelectric, it might be 10K or more. In any case, a resistor equal to the speaker impedance would be a good place to start.

best practice is to use some sort of crossover to seperate the tweeter from the other speakers

Robert Reed
Posts: 2276
Joined: Wed Nov 24, 2004 1:01 am
Location: ASHTABULA,OHIO
Contact:

Post by Robert Reed » Wed Aug 30, 2006 2:30 pm

Back in the days when Tri-axial speakers were popular, the better systems came with "Brilliance Controls" wired to them. This was merely a 25 ohm-5 watt-wirewound pot in series with the tweeter portion of the speaker. Crude and simple - yes, but you could hear the difference as they took some of the artificial crispness out of the sound.

Post Reply

Who is online

Users browsing this forum: No registered users and 5 guests