Wanted ... in any conditon
Satellite Model 303 Digital Clock
was made in the late 1970's
Unit used 4 LED Displays for time
Came in a Low Profile case
which was 1" x 3" x 3" .. was
available in Brushed Aluminum
or Brushed Gold Color
Any condition accepted
Working or not
Thanks much
Item Wanted
- dacflyer
- Posts: 4749
- Joined: Fri Feb 08, 2002 1:01 am
- Location: USA / North Carolina / Fayetteville
- Contact:
got a foto of this clock ?
whats so special about it ?
share the interest clock lover here too
just for grins,,have a look at this gigantic clock,,
2 feet tall and 12 feet wide green led digits !
http://www.sparkfun.com/commerce/presen ... GPSClock-1
accurate to 100ns. wow !
whats so special about it ?
share the interest clock lover here too
just for grins,,have a look at this gigantic clock,,
2 feet tall and 12 feet wide green led digits !
http://www.sparkfun.com/commerce/presen ... GPSClock-1
accurate to 100ns. wow !
Neat. I wanted to do this same type of project with 24" fluorescent tube fixtures, using the cheap "mount anywhere" fixtures. You know the type, the ones that are mostly just the tube and the "case" is just barely bigger than the tube itself. At $15 to $20 each one seven segment display would cost $140. Times six $840. And this is just for the lights!
So....If you don't mind my asking....What kind of money would I be spending if I duplicated your project?
So....If you don't mind my asking....What kind of money would I be spending if I duplicated your project?
No trees were harmed in the creation of this message. But billions of electrons, photons, and electromagnetic waves were terribly inconvenienced!
dacflyer
No photo at this time ... will try to get on
The nice thing about this clock was it
Extremly Smalll ... only 3 inches square
& 1 inch high .. it sat on a small angled
pedestal ... the case was the best looking
I had ever seen ... Miine has some broken
pcb traces & I can't seem to make a good
board, since it is very tiny
No photo at this time ... will try to get on
The nice thing about this clock was it
Extremly Smalll ... only 3 inches square
& 1 inch high .. it sat on a small angled
pedestal ... the case was the best looking
I had ever seen ... Miine has some broken
pcb traces & I can't seem to make a good
board, since it is very tiny
Who is online
Users browsing this forum: No registered users and 160 guests