Terminals for ATO fuse block?

This is the place for any magazine-related discussions that don't fit in any of the column discussion boards below.
Post Reply
helgrind
Posts: 9
Joined: Mon Aug 26, 2002 1:01 am
Contact:

Terminals for ATO fuse block?

Post by helgrind » Thu Sep 18, 2003 9:33 pm

I'm looking for the terminals that fit into ATO type fuse blocks and can't seem to find them anywhere... any suggestions? thanks!

User avatar
Edd
Posts: 885
Joined: Sun Jan 27, 2002 1:01 am
Location: Dallas Tx
Contact:

Re: Terminals for ATO fuse block?

Post by Edd » Thu Sep 18, 2003 10:29 pm

Clarification, or it might just be a matter of semantics,
<terminals that fit into ATO type fuse blocks >
, would that be connect onto ATO type fuse blocks. Seems like connect into would infer as to a male bladed terminal inserted in the place of the fuse proper.
Seems like I remember male push on clips commonly being for ¼ in width female companions but also there is the 3/16 in width and even an 1/8 in width. Any chance yours is the smaller 3/16 in unit…or even a metric size ??
Ckeck this site and see if it is of any help for info or mainly even more important for a common visual reference for further query.
http://www.electerm.com/holder.html<p>73's de Edd
[email protected] ........(Interstellar~~~~Warp~~~Speed)
[email protected]........(Firewalled-Spam*Cookies*Crumbs)
;)

Post Reply

Who is online

Users browsing this forum: No registered users and 27 guests