Need help with motor control circuit
Posted: Sun Nov 07, 2004 4:32 pm
I am working on a linear actuator (which is basically a electric screw press). I am having to wire up my own motor control circuit. I have attached the factory schematic, but I am having trouble identifying a few components. There are several components that look like capacitor symbols (K1 (2 each) & K2 (2 each)) but they don't list any specifications (any help appreciated on sizing). Also, there is two other items labeled K1 and K2 that I can't identify the symbols (are they the relays discussed in Note #4 at the bottom of the schematic?). I have a fairly basic electronics background so I could sure use a little help. I already have the motor capicator shown (35 uf 360 volts). I can figure out the DPDT switch).