Dear readers of Nuts & volts.
I need someone to design p.c.b. layouts on their own computer. I will supply the schematics. My phone # is 570-282-5110 ex-5 my address for snail mail is Craig Kendrick Sellen at Birch Hills Residence 25 reservoir St. Simpson PA 18407-1300
making p.c.b.'s layouts
- Dave Dixon
- Posts: 436
- Joined: Thu May 01, 2003 1:01 am
- Location: Wichita, KS
- Contact:
Re: making p.c.b.'s layouts
Craig,
How extensive a schematic do you have. I
can probably find time if it's not very complex.
I'll need packaging information for the specific
components you want to use as well as the
schematic. I'll also need to know what board
dimensions and mounting hole locations if you
know them.
For fastest reply, email me at [email protected]
Good luck,
Dave
How extensive a schematic do you have. I
can probably find time if it's not very complex.
I'll need packaging information for the specific
components you want to use as well as the
schematic. I'll also need to know what board
dimensions and mounting hole locations if you
know them.
For fastest reply, email me at [email protected]
Good luck,
Dave
Re: making p.c.b.'s layouts
Also, as with the previous response, it
depends on lhow complex a job. Also, if
it is an RF design.m There are several free/low cost layout programs available (EasyTRax for one).
Mark
depends on lhow complex a job. Also, if
it is an RF design.m There are several free/low cost layout programs available (EasyTRax for one).
Mark
- Dave Dixon
- Posts: 436
- Joined: Thu May 01, 2003 1:01 am
- Location: Wichita, KS
- Contact:
Re: making p.c.b.'s layouts
Craig,
I sent 2 e-mails to the hotmail address that
you gave me. Did I get it wrong? I can't
promise that I can help, but need a few answers
first on your board needs.
Please email me at [email protected].
Dave
I sent 2 e-mails to the hotmail address that
you gave me. Did I get it wrong? I can't
promise that I can help, but need a few answers
first on your board needs.
Please email me at [email protected].
Dave
Who is online
Users browsing this forum: Majestic-12 [Bot] and 153 guests