Has anyone have a 10vdc wll-wart for a SPEP Eprom Programmer from Futerlec.
I just bought this "thing", and all the futurlec website says is that it requires that wall wart, but I haven't found any info. on the amp's or if it is center-positive or vice-versa.
I've looked on "google", but no luck.
Any help would be appreciated!
Power supply needed for a Futerlec EPROM Programmer
Re: Power supply needed for a Futerlec EPROM Programmer
open up the device and see what the connector goes to. If it's dc it should be pretty obvious what the center is. You can probably get a sense of the power requirements from the regulator.
Phil
<small>[ March 08, 2006, 09:59 PM: Message edited by: philba ]</small>
Phil
<small>[ March 08, 2006, 09:59 PM: Message edited by: philba ]</small>
Re: Power supply needed for a Futerlec EPROM Programmer
Hi DAVID,
I found this catalog in Thailand. It states that the spep plus needs 10VDC, but no amps. I hope this helped!
http://www.etteam.com/catalog/Catalog2004/Page50-55.pdf
Middle of page 51.
TOK
I found this catalog in Thailand. It states that the spep plus needs 10VDC, but no amps. I hope this helped!
http://www.etteam.com/catalog/Catalog2004/Page50-55.pdf
Middle of page 51.
TOK
Gorgon the Caretaker - Character in a childrens TV-show from 1968.
Who is online
Users browsing this forum: No registered users and 17 guests