Instrumentational Amplifier

This is the place for any magazine-related discussions that don't fit in any of the column discussion boards below.
Post Reply
Turbo46
Posts: 27
Joined: Mon Apr 12, 2004 1:01 am
Location: uk
Contact:

Instrumentational Amplifier

Post by Turbo46 » Tue Apr 13, 2004 3:57 am

Hi<p>Im currently trying to alter the input impedance of an operational
amplifier, but cant find the right page on google. I think impedance
means, there must be an RC circuit in series with the amplifier? Does
anybody have any ideas?

rosborne
Posts: 73
Joined: Mon Jun 23, 2003 1:01 am
Contact:

Re: Instrumentational Amplifier

Post by rosborne » Tue Apr 13, 2004 11:29 am

The impedance of an op-amp closed loop is very large. Even open loop I think you will see impedances in the range 20K and IIRC the impedance closed loop is about the open loop gain (A) times the open loop impedance or 20k * 70k or thereabouts. These values are determined by the designers of the IC and the physical geometry of the IC not by the applications engineer.
-Rick

Ron H
Posts: 360
Joined: Tue Dec 18, 2001 1:01 am
Location: Boise, ID
Contact:

Re: Instrumentational Amplifier

Post by Ron H » Tue Apr 13, 2004 11:32 am

There are no ideal op amps in the real world, meaning that all of them have finite input impedance (usually parallel R-C). Do you have a particular one in mind? What problem is the input impedance causing?

Dean Huster
Posts: 1263
Joined: Wed Dec 05, 2001 1:01 am
Location: Harviell, MO (Poplar Bluff area)
Contact:

Re: Instrumentational Amplifier

Post by Dean Huster » Tue Apr 13, 2004 12:00 pm

If you're talking about the input impedance of the entire circuit, it's easy to alter. If you're working with a standard inverting amplifier circuit, the input impedance is the same as the value of the input resistor. If working with a standard non-inverting amplifier circuit, simply hang a resistor from the input of the op amp to ground with a value that's equal to the input impedance you desire. All resistances used in these standard op amp circuits must have values that are at least a factor of 4 to 10 lower in value that the intrinsic input impedance of the op amp itself. If you work with FET input op amps, the value of these resistors (input resistance and feedback resistance) almost becomes a moot point.<p>Dean
Dean Huster, Electronics Curmudgeon
Contributing Editor emeritus, "Q & A", of the former "Poptronics" magazine (formerly "Popular Electronics" and "Electronics Now" magazines).

R.I.P.

Post Reply

Who is online

Users browsing this forum: No registered users and 8 guests