solder past dispensers

This is the place for any magazine-related discussions that don't fit in any of the column discussion boards below.
Post Reply
Posts: 38
Joined: Tue Jun 01, 2004 1:01 am
Location: Deep 13

solder past dispensers

Post by LucidGuppy » Thu Jan 20, 2005 12:19 pm

Does anyone have a solder paste dispensor setup in their lab? I just wanted to see what other people were working with - especially their source for compressed air for the dispenser.
Why don't you give yourself a nice big round of applause!

User avatar
Chris Smith
Posts: 4325
Joined: Tue Dec 04, 2001 1:01 am
Location: Bieber Ca.

Re: solder past dispensers

Post by Chris Smith » Thu Jan 20, 2005 5:04 pm

One good tool is the hypos that are used with ink refill kits. Other than that a acid brush and tin can that can be rewarmed and melted back into a clean paste when the debris floats to the top for scraping off to keep it clean.

Posts: 26
Joined: Mon Jan 17, 2005 1:01 am

Re: solder past dispensers

Post by wolfcreek » Thu Jan 20, 2005 7:55 pm

I originally had a commercial dispenser system but went to the prefilled paste syringes with a plunger and plastic tip. I found the hand method easier to control than the pressurized system. The auto dispenser systems can make quite a mess if you are not very careful( the manual ones can too for that matter :) ) Contact-East has 35 gm syringe bodies of Kester paste for about $10.00. The plunger and tip are each 1.00.

Post Reply

Who is online

Users browsing this forum: No registered users and 31 guests