remote control servos connection to stamp

This is the place for any magazine-related discussions that don't fit in any of the column discussion boards below.
Post Reply
Posts: 1
Joined: Sat Aug 10, 2002 1:01 am
Location: laguna woods

remote control servos connection to stamp

Post by drmaack » Sat Aug 10, 2002 8:56 am

I would like to use a remote control servo from a model airplane to steer a car. Can you conect these things to a stamp type computer easily. Ultimate aim is to make a car follow magmets in road surface. I don't know very much about this stuff.<p>drmack

Post Reply

Who is online

Users browsing this forum: No registered users and 11 guests