T&L Publications

I got hold of a lot of Li-po batteries, but I'm having a hard time to find any JST Male pigtails
Kind of like this..
https://alexnld.com/product/10-pcs-jst- ... pv-racing/
I'm not having much luck.. there's plenty of female connectors tho..
I need about 60 of these..

Sorry, those are Micro mini. Maybe these:

https://www.amazon.com/2-0MM-Connector- ... B01IZBMX7S

JWAX >> the ebay ones are female connectors, and i don't shop Amazon.. they are on my shit list..lol
But i what to search for now..Thanks

I came a cross these on Digikey.

https://www.digikey.com/product-detail/ ... ND/1530483

Hope this will work for you , though It would be great if I had an actual picture of the female plug to match it by.


Signed: Janitor Tzap

Those Digikey are 2.5mm, but if anybody would have what dacflyer is after, it would be Digikey.

Janitor Tzap >> those are PC mount,, i need pigtails... I'm not having much luck yet.

dacflyer wrote: ↑Thu Jul 02, 2020 6:55 am Janitor Tzap >> those are PC mount,, i need pigtails... I'm not having much luck yet.

So????

If it is the right connector.
Solder on the wires to the connector.
Then cover the soldered end to the connector with either hot glue, or RTV Silicon Sealant.
Let dry, and your good to go.

But as I said before......

It would be great if I had an actual picture of the female plug to match it by.

EDIT:
Here is the Digikey page with the 2mm jst Male & Female connectors.
https://www.digikey.com/catalog/en/part ... eries/2825


Signed: Janitor Tzap

it's not feasible for me to do this...i have over 60 i'd have to make.
that's why i am looking for something ready made..

Hmmmm......................

Well,
They do sell the connector, plus pre-crimped wire ends that fit the connector.
https://www.digikey.com/products/en/con ... ageSize=25

Your still going too need to do some assembly and possible soldering.


Signed: Janitor Tzap

I'll see if they might send me a sample.
I see online they sell the already female pigtails, but not male ones..Guess they are not popular.

Female connectors are normally used for source connections while male pins are for the load, this helps prevent accidental short circuit if the source by enclosing the pin in the connector body. If pigtails are mainly used on the battery, it makes sense most would be F, while M connectors are more typically board mount. if you want a thru connector with pigtails on both sides, maybe you need to swap for another style.

These are the packs I am using..

https://batteryhookup.com/products/lith ... wh-w-bms-1
I bought 60 of them..

I think you're going to have to attach your own wires to the header component, then you can insulate with heat shrink or hot glue

I agree with haklesup,

The connector is designed to plug in to this type of header.

https://www.digikey.com/catalog/en/part ... eries/2825

So, any way you look at it.
Your going to be doing a lot of soldering.


Signed: Janitor Tzap