Hello to the group I hope someone and help me.
I have a older BC350C Police scanner and I would like to know were I can tap into or test point to read the input signal strength of the stations I receive.
I want to measure it with a digital volt meter while
trying different antennas
Thank you for any help you may offer
Uniden Bearcat 350c help
- dacflyer
- Posts: 4748
- Joined: Fri Feb 08, 2002 1:01 am
- Location: USA / North Carolina / Fayetteville
- Contact:
Re: Uniden Bearcat 350c help
do you by chance have a link to a schematic ?
Re: Uniden Bearcat 350c help
sorry I do not and only thing I was able to find was the owners manual.Was looking for a service manual that I felt would help but no luck.
-
- Posts: 2277
- Joined: Wed Nov 24, 2004 1:01 am
- Location: ASHTABULA,OHIO
- Contact:
Re: Uniden Bearcat 350c help
Usually done by tapping into AGC circuitry- but again, you will need schematic.
Re: Uniden Bearcat 350c help
Found a place that had schematics...But not yours...http://w5jgv.com/downloads/Bearcat/
Maybe it'll help..
Maybe it'll help..
Re: Uniden Bearcat 350c help
The place I go to for rf info is http://www.radioreference.com
They have a section (forums) just for Uniden scanners, I also program Motorola and Vertex radios, they have sections for them as well.
They have a section (forums) just for Uniden scanners, I also program Motorola and Vertex radios, they have sections for them as well.
Who is online
Users browsing this forum: No registered users and 6 guests