Page 1 of 1

Q and A Column by Russell Kincaid

Posted: Fri May 30, 2014 10:44 pm
by jollyrgr
Was the Q and A column discontinued and I just missed the announcement?
I think the last time it was published was back in February.

Re: Q and A Column by Russell Kincaid

Posted: Sat May 31, 2014 5:47 am
by CeaSaR
Sadly, Russ gave his notice back then and Q & A is on hiatus until another guru will step up to the plate. If you know someone that can troubleshoot, repair, design, code, and write, tell them to send a sample to N & V. Hopefully, this drought will soon end.

CeaSaR

Re: Q and A Column by Russell Kincaid

Posted: Mon Jun 02, 2014 4:35 am
by dacflyer
i am surprised that there is not a Q&A here that is linked to the magazine.
or the tech forum for that matter.

Re: Q and A Column by Russell Kincaid

Posted: Wed Jun 11, 2014 5:58 pm
by jollyrgr
dacflyer wrote:i am surprised that there is not a Q&A here that is linked to the magazine.
or the tech forum for that matter.
Tech Forum is here:

http://www.nutsvolts.com/tech-forum

Re: Q and A Column by Russell Kincaid

Posted: Thu Jun 12, 2014 11:16 am
by dacflyer
i ment that the Q&A should have a link with in the forum here..

Re: Q and A Column by Russell Kincaid

Posted: Sat Jun 14, 2014 8:11 am
by CeaSaR
It does. It is listed out on the main/home page underneath / below "Smiley's Workshop".

CeaSaR

Re: Q and A Column by Russell Kincaid

Posted: Mon Jun 16, 2014 4:30 am
by dacflyer
my mistake, I been out in the heat all day and hot/tired etc, i ment to say was. the "tech forum."

Re: Q and A Column by Russell Kincaid

Posted: Fri Jul 04, 2014 7:55 pm
by Tron
The Q and A column by Russ was my favorite part of the magazine. I hope they can find a guy just as intelligent as Russ, especially in designing electrical circuits.

Thanks, BJM

Re: Q and A Column by Russell Kincaid

Posted: Mon Jul 07, 2014 6:48 pm
by CeaSaR
Q&A was one of the first things I read each issue. Sure hope it returns soon.

CeaSaR

Re: Q and A Column by Russell Kincaid

Posted: Tue Jul 08, 2014 3:47 am
by dacflyer
Q&A and tech forum were about the main parts of the magazine i'd always read 1st
never was enough of it for me,, i loved it.

Re: Q and A Column by Russell Kincaid

Posted: Fri Jul 25, 2014 8:11 pm
by CeaSaR
Good news! Q&A will be back in either October or November with Tim Brown at the helm. You can read Vern Graner's full reply in Reader Feedback, page 73, of the August 2014 issue.

Thanks Vern, and welcome Tim!

CeaSaR

Re: Q and A Column by Russell Kincaid

Posted: Sat Jul 26, 2014 6:22 am
by dacflyer
cool deal... will it be on here as well ?

Re: Q and A Column by Russell Kincaid

Posted: Sun Jul 27, 2014 7:35 am
by CeaSaR
Didn't say in the write up, but when the board was broken up into all the different categories, the intent was to have a section for each of the individual columns, to which the current author could reply.

CeaSaR