## Circuit for keeping voltage below a certain amount

This is the place for any magazine-related discussions that don't fit in any of the column discussion boards below.
VacuumTube194
Posts: 7
Joined: Sun Jul 01, 2007 6:37 am
Contact:

### Circuit for keeping voltage below a certain amount

I need a circuit that will maximize a voltage. What I mean is the voltage may vary, but I want it
so if the input goes above 30 volts, then it will send 30 volts only through the output. I don't want the
voltage cut off (like a fuse) if it goes above that amount. Does anyone have any suggestions?

dyarker
Posts: 1735
Joined: Fri Aug 22, 2003 1:01 am
Location: Izmir, Turkiye; from Rochester, NY
Contact:

### Re: Circuit for keeping voltage below a certain amount

how much current we need to dump?
Dale Y

VacuumTube194
Posts: 7
Joined: Sun Jul 01, 2007 6:37 am
Contact:

### Re: Circuit for keeping voltage below a certain amount

dyarker wrote:how much current we need to dump?

Robert Reed
Posts: 2276
Joined: Wed Nov 24, 2004 1:01 am
Location: ASHTABULA,OHIO
Contact:

### Re: Circuit for keeping voltage below a certain am

What you want is called a "Clamping Circuit". Google that up for a wealth of information on the subject.

Dimbulb
Posts: 324
Joined: Sun Oct 13, 2002 1:01 am

### Re: Circuit for keeping voltage below a certain amount

You could use a series regulator.
First build a standard zener circuit to get a tiny 10mA of 31 volts
this has little noise and can be filtered if it becomes critical.

Try to have at all times at least 33V unregulated.
then when add a series regulator you can adjust it to exactly 30V

Dimbulb
Posts: 324
Joined: Sun Oct 13, 2002 1:01 am

### Re: Circuit for keeping voltage below a certain amount

sorry for having to post twice
this forum has the edit function disabled and the FAQ is incoorect !!!
time to look for a different forum

the series circuit should have a transistor
http://www.tpub.com/neets/book7/27k.htm

sorry again the edit function is really important
to continued success of this forum !

haklesup
Posts: 2978
Joined: Thu Aug 01, 2002 1:01 am
Location: San Jose CA
Contact:

### Re: Circuit for keeping voltage below a certain amount

A 30V Zener diode should do it all by itself as a clamp. 1N5363B should do the trick. its a 5W part and can dump a whole lot more than 100mA if need be.

I edit all the time, not sure why you can't. It used to be having the wrong skin would eliminate certain functions but I don't see skin selection in the control panel anymore. Try PM the sysop for a fix. My edit button is in the upper right corner of my posts (last sentence added by edit)

Bob Scott
Posts: 1192
Joined: Wed Nov 20, 2002 1:01 am
Location: Vancouver, BC
Contact:

### Re: Circuit for keeping voltage below a certain amount

All you need is a 3 terminal voltage regulator with low dropout. (If you don't mind a slight bit of dropout.)

In order to edit, check to make sure you are logged in. You can only edit messages that you authored.
-=VA7KOR=- My solar system includes Pluto.

### Who is online

Users browsing this forum: No registered users and 42 guests