Upping LM781 Output Voltage

This is the place for any magazine-related discussions that don't fit in any of the column discussion boards below.
Post Reply
Yerry
Posts: 40
Joined: Wed Mar 02, 2005 1:01 am
Location: Kentwood, MI USA
Contact:

Upping LM781 Output Voltage

Post by Yerry » Sun Feb 06, 2011 9:37 pm

I have a small pile of LM7815 regulators. Can I take advantage of the .6V silicon voltage drop and add a few diodes between the ground pin and actual ground to raise the output voltage? I need to drop 24v from two sealed lead-acid batteries down to about 18 volts or so; regulation isn't critical and load is about 300mA.

sghioto
Posts: 320
Joined: Wed Dec 26, 2007 5:16 pm
Location: Colorado
Contact:

Re: Upping LM781 Output Voltage

Post by sghioto » Mon Feb 07, 2011 12:15 pm

add a few diodes between the ground pin and actual ground to raise the output voltage
Yes you can using diodes or a voltage divider from the output to ground the same way a LM317 regulator is configured.

Steve G.

Robert Reed
Posts: 2276
Joined: Wed Nov 24, 2004 1:01 am
Location: ASHTABULA,OHIO
Contact:

Re: Upping LM781 Output Voltage

Post by Robert Reed » Mon Feb 07, 2011 9:24 pm

I have raised 78xx regulator's voltage many times with just a single resistor inserted in its ground lead. You will have to do this experimentally though as each chip will want a slightly different value. For a three volt jump, 470 ohms would be a good starting point. However, I am not sure how this method as compared to Steve's suggestion would affect CRITICAL regulation more. But it sounds like you don't need laboratory precision here.

Einar M
Posts: 20
Joined: Sun Dec 26, 2010 10:27 pm
Location: Calif.
Contact:

Re: Upping LM781 Output Voltage

Post by Einar M » Wed Feb 09, 2011 7:56 pm

Steve's suggestion is the right way. Connecting a resistor from out to 'gnd' pin swamps out the variation in Iq that occurs between units and with varying loads. 10 to 20 mA is recomended, so 1K from out to 'gnd' and 200 ohm from there to gircuit gnd would give 18V out.

Post Reply

Who is online

Users browsing this forum: Bing [Bot] and 9 guests