I need the dimensions of one of those right angle power cords, the type that could plug into a computer
power supply and instead of sticking right out from the case it angles 90 degrees so the cord runs
parallel to the back of the case rather than sticking out a bit.
The type of connector is known as "IEC 320-C13".
The dimension i need is the connector length that plugs into the computer power supply power socket.
That is, the length of that part that fits into the socket plus the length of the part that does not
fit into the socket.
If someone has one and can measure it that would be nice...thanks. Accuracy to the nearest 1/16 inch
should be good enough.
Here's a rough drawing showing the connector with the wire and the dimension i need...
Code: Select all
LENGTH
<---------------------->
----------------------
| |
| | (this end plugs into the PC power supply power socket)
| |
| |
----------------------
| |
| |
| |
| |
| | (this is the 120vac wire)
| |
| |
| |
*
*
(goes to 120vac wall socket plug)