Combining UHF > VHF Antenna

This is the place for any magazine-related discussions that don't fit in any of the column discussion boards below.
Post Reply
Posts: 37
Joined: Tue Sep 09, 2003 1:01 am
Location: AR

Combining UHF > VHF Antenna

Post by tonybackache » Fri Feb 05, 2010 3:02 pm

I recently put a Channel Master Model 4228 UHF antenna in my attic. Discovered a few of the locals (Memphis, TN) I'm trying to receive are on the VHF Band. What would be a good VHF antenna to purchase and how would I connect the 2?

Posts: 322
Joined: Wed Dec 26, 2007 5:16 pm
Location: Colorado

Re: Combining UHF > VHF Antenna

Post by sghioto » Fri Feb 05, 2010 7:06 pm

I don't have a recommendation for a VHF antenna but
you can connect the two using a splitter/combiner, like this one from Radio Shack. ... Id=2062059#

This particular model has a 300ohm UHF input. Just run 300ohm twin-lead straight from the Channel Master antenna to the splitter input eliminating the transformer or find a splitter with 75 ohm inputs.

Steve G.

Robert Reed
Posts: 2276
Joined: Wed Nov 24, 2004 1:01 am

Re: Combining UHF > VHF Antenna

Post by Robert Reed » Fri Feb 05, 2010 9:48 pm

As usual Radio Shack is advertising a Splitter, yet the pix shows a 75/300 ohm balun. So what are they really selling here is any body's guess :sad:
A high quality splitter can usually be used as a combiner, but most consumer devices probably don't fit the bill.

User avatar
Janitor Tzap
Posts: 1510
Joined: Sat Aug 12, 2006 5:17 pm

Re: Combining UHF > VHF Antenna

Post by Janitor Tzap » Sat Feb 06, 2010 10:18 pm

Well, Tony......

First off you should go to
And check where these station are, relative to where you are.

Use the "Radar Plot".
This will show what direction and relative signal strength to expect at your location.
As well as help you determine what type of antenna will work best, and where to point it.

Most people are using RG-6 75 ohm cabling for their antenna setups.

Basically, you have a 300 ohm to 75 ohm transformer connected directly at the antenna.
With RG-6 75 ohm cabling then coming down to a Combiner/Splitter,
with 75 ohm inputs & outputs that will then go to your TV set or Set Top Box Tuner.

Here's a helpful PDF file that goes into setting up Over Air Antenna systems.

Signed: Janitor Tzap

Posts: 1
Joined: Mon Feb 08, 2010 11:25 am

Re: Combining UHF > VHF Antenna

Post by hcheetham » Mon Feb 08, 2010 11:29 am

the 4228 should receive vhf and uhf.the 4221 only receives uhf.try turning the antenna and then rescan.with digital you got to be pointed towrd the station almost directly on the signal.

Post Reply

Who is online

Users browsing this forum: No registered users and 42 guests