Electronic Component Store ?

This is the place for any magazine-related discussions that don't fit in any of the column discussion boards below.
Post Reply
Borisw37
Posts: 14
Joined: Wed Apr 06, 2005 1:01 am
Location: USA
Contact:

Electronic Component Store ?

Post by Borisw37 » Tue Feb 07, 2006 2:07 pm

I am looking for a NON-Mail Order store that carries a decent selection of electronic components that is NOT Radio Shack.
I try to order things online but once in a while I need to get something same day.

I live in the Philadelphia, PA area.

Thank you,

Boris.

User avatar
dacflyer
Posts: 4455
Joined: Fri Feb 08, 2002 1:01 am
Location: USA / North Carolina / Fayetteville
Contact:

Re: Electronic Component Store ?

Post by dacflyer » Tue Feb 07, 2006 2:41 pm

our electronic store here sucks too, they are turning into a SHI* SHACK in a way also..
99% of the time i try to get somehting , they say
we do not have it,, but we can order it,, but you will have to wait 2-3 weeks..till we get a full order.
but they sell pleanty of survelance , security , cell equipment etc..Grrrr !

Tommy volts
Posts: 149
Joined: Tue Oct 29, 2002 1:01 am
Location: Arizona
Contact:

Re: Electronic Component Store ?

Post by Tommy volts » Tue Feb 07, 2006 3:37 pm

Boris,

try looking for a good Radio Shack again, it'll have about 50% of most of the common components you'll need.

Fry's Electronics is out here on the west coast, not sure if there where you are yet, but Fry's is like the Walmart (do they have those in PA?) of the electronic components industry.

What is it your looking for? what project are you working on?

Robert Reed
Posts: 2276
Joined: Wed Nov 24, 2004 1:01 am
Location: ASHTABULA,OHIO
Contact:

Re: Electronic Component Store ?

Post by Robert Reed » Tue Feb 07, 2006 3:56 pm

Boris
Let your Fingers do the walking--in the yellow pages that is. Almost every major city will have a surplus outlet.Theres been anywhere from 1-5 in the Cleveland area forever.

User avatar
haklesup
Posts: 2972
Joined: Thu Aug 01, 2002 1:01 am
Location: San Jose CA
Contact:

Re: Electronic Component Store ?

Post by haklesup » Tue Feb 07, 2006 4:19 pm

Its hard to find what you want in any area. Even if you find a store it will often not have what you want or have it at a high price. The fact is that electronic components have a tremendous selection available.

In Philly I doubt there is much ( I assume you screened the yellow pages). I would look at phone pooks in the NJ, NYC area. It would only be a few hours ride (Hmmm, postage is looking better already)

Not Too Far:
http://www.extremecomponents.com/?src=g ... _inventory

A reference within this link to a philly store:
http://members.aol.com/kg4erx/surplus.htm
(A bit out of date I can see Alltronics has moved since)

This one is Ohio-centric but has good links: http://www.logwell.com/tech/components/ ... rplus.html

User avatar
jwax
Posts: 2156
Joined: Mon Feb 09, 2004 1:01 am
Location: NY
Contact:

Re: Electronic Component Store ?

Post by jwax » Wed Feb 08, 2006 4:01 am

Fry's on-line store:
http://www.outpost.com/
Assuming you can wait overnight for hot projects!

plunt
Posts: 9
Joined: Thu May 02, 2002 1:01 am
Location: Virginia
Contact:

Re: Electronic Component Store ?

Post by plunt » Wed Feb 08, 2006 10:13 am

I found the same problem down here in Northern Virginia. Web searchs, telephone searches etc. come up empty. But thru a local Ham Radio person, I was pointed to Arcade Electronics in Springfield. Very good store for populuar parts, they carry some subset of the Jameco line for example. Lot's of connectors, boards, boxes, instruments etc. Maybe check with a local Ham Radio club.

L. Daniel Rosa
Posts: 400
Joined: Tue Dec 25, 2001 1:01 am
Location: Bellingham, WA
Contact:

Re: Electronic Component Store ?

Post by L. Daniel Rosa » Fri Feb 10, 2006 2:42 am

My local hardware store carries a selection that rivals (and soon to better) RS.

User avatar
Edd
Posts: 885
Joined: Sun Jan 27, 2002 1:01 am
Location: Dallas Tx
Contact:

Re: Electronic Component Store ?

Post by Edd » Fri Feb 10, 2006 4:47 am

Check out these references to Philly sites:
http://www.shopatphilly.com/electronics.html

Fertrik’s Electronics may have some surplus electronics, as was referenced in a Ham site. Or better yet, go directly to that site, as there might be some “bedroom community “ towns also listed.
See:
http://www.geocities.com/CapeCanaveral/ ... rtsupp.htm

By all means , read completely through, and check out the inventory at Dirty Dan Mc Graw’s mail order site:

http://www.danssmallpartsandkits.net

How well I remember the suppliers of yore , also Poly Paks by mail order and a local store …Olson’s….that would sell 6 and 12 in sq cardboard boxes of surplus or manufacturers over runs of parts.
A nostalgia thread:
http://www.childhoodradios.com/board/bo ... htm?page=1

L Daniel Rosa……et…..Philba:
When in Washington...KJR land.... I used to frequent Boeing’s surplus sales store, and some nearby spin offs, for bargain wire/electrical & electronic components /alum, etc. Do you know if that still holds true ?

73's de Edd
[email protected] .........(Interstellar~~~~Warp~~~Speed)
[email protected].........(Firewalled*Spam*Cookies*Crumbs)
:(

<small>[ February 10, 2006, 06:03 AM: Message edited by: Edd Whatley ]</small>

Dean Huster
Posts: 1263
Joined: Wed Dec 05, 2001 1:01 am
Location: Harviell, MO (Poplar Bluff area)
Contact:

Re: Electronic Component Store ?

Post by Dean Huster » Fri Feb 10, 2006 6:22 am

Grab all the old magazines and write off to all the mail-order outfits you can find. When you get the catalogs, check them out as many have stores at their base location. Some stores, like Gateway Electronics in St. Louis (and later Denver) began as surplus stores and then went mail order in addition, keeping their stores as their primary outlets.

Oklahoma City has a store, so they're out there even though it is harder to compete with mail order and the Internet. As mentioned, use the Yellow Pages to search them out. Check with the local ham radio clubs as the old-timers will know. Check to see if there are any vocational schools that still have electronics programs and see if the instructor knows of stores.

I also eschew Radio Shack for anything other than common connectors. Don't ever buy coax from them unless you can stand less than 50% shield coverage. Ever since they started pushing the consumer electronics, they've never been good parts stores, typically carrying only three or four TTL devices, for instance. In 1965, Radio Shack was a pretty good store for parts, carrying a lot of surplus, too.

Dean
Dean Huster, Electronics Curmudgeon
Contributing Editor emeritus, "Q & A", of the former "Poptronics" magazine (formerly "Popular Electronics" and "Electronics Now" magazines).

R.I.P.

User avatar
MicroRem
Posts: 203
Joined: Tue Dec 04, 2001 1:01 am
Location: Vancouver, WA USA
Contact:

Re: Electronic Component Store ?

Post by MicroRem » Fri Feb 10, 2006 5:40 pm

Edd, I work in Seattle and Kent often (in fact I was in Seattle this afternoon). Next time I'm up that way i'll see if the Boeing Surplus store is still going. I remember the guy who bought a 727 flap motor and used it to power his scale RC tugboat, that could pull a fully loaded ski boat with ease...

regards

Tom

Post Reply

Who is online

Users browsing this forum: Bing [Bot] and 15 guests