stepper grid software
stepper grid software
Any open source software to control printer steppers? I have a plasma cutter and want to translate simple outline graphic figures into stepper commands to operate typical printer (old battleship Epson FX-85)stepper motors in X-Y plane. Thanks
- Clyde Crashkop
- Posts: 99
- Joined: Fri Feb 06, 2004 1:01 am
- Location: Florida
- Contact:
Re: stepper grid software
If you are or want to run 3 printer motors directly from your parallel port, let me know. I will send schematic and sample program. You can probably make it accept Gerber files.
No charge.
Dave
No charge.
Dave
- Clyde Crashkop
- Posts: 99
- Joined: Fri Feb 06, 2004 1:01 am
- Location: Florida
- Contact:
Re: stepper grid software
BTW Assuming your printer circuit board is still intact, the only parts you will need is 8 or 12 resistors to drive the gates on the motor coil transistors and 1 inverter chip if you can’t find one on the board.
Who is online
Users browsing this forum: Bing [Bot] and 90 guests