newbi question on relays

This is the place for any magazine-related discussions that don't fit in any of the column discussion boards below.
Post Reply
Posts: 75
Joined: Mon Aug 29, 2005 1:01 am

newbi question on relays

Post by paulsantangelo » Mon Aug 29, 2005 7:41 pm

Sorry, I know this is a stupid question, but can someone please tell me how one would place a standard PCB relay on a breadboard? The common pin seems a bit out of place to fit into a slot.<p>Thanks

Posts: 115
Joined: Sun May 15, 2005 1:01 am

Re: newbi question on relays

Post by rstofer » Mon Aug 29, 2005 7:55 pm

Lay it upside down and use small jumpers for all of the pins. Just solder them on and remove them when you are finished.

Post Reply

Who is online

Users browsing this forum: No registered users and 30 guests