Electronics Computer Programming Q&A
- Posts: 1
- Joined: Wed Sep 06, 2006 7:04 pm
I'm looking for assistance in "upgrading" a control board from soldered components to a microcontroller. I am not electrically gifted but would like to talk to someone that can assist me in component layout and programming of the microcontroller. I have a schematic and working unit as a start.
Helpful guidance would be appreciated - and remunerated.
- Posts: 122
- Joined: Sun Apr 17, 2005 1:01 am
- Location: Victoria BC
Post the schematic and let us have a look.
There is only one correct answer, mine.
- Posts: 1044
- Joined: Tue Dec 04, 2001 1:01 am
- Location: Australia
Yup, perhaps a greater description of what you need the controller to controll would help.
Anyhoo, I do commission work - see my webpage, but ignore the home page - it's been GOT AT
and is all skew whiff.
On a clear disk you can seek forever.
- Posts: 366
- Joined: Tue Jan 18, 2005 1:01 am
- Location: Orlando FL
what micro are you using? most data sheets tell you how to layout the board.. or have a demo you can look at for free.
Users browsing this forum: No registered users and 3 guests