Electronics Computer Programming Q&A
Post Reply
Posts: 1
Joined: Fri May 14, 2004 1:01 am
Location: Ar.


Post by veteran6519 » Fri May 14, 2004 10:49 am

Did you ever get the message while programming a 16F84A "failed at 0000h", Well that's all I ever get using the Talkingelectronics kit's .
If you know what I might be doing wrong ,please respond.

L. Daniel Rosa
Posts: 400
Joined: Tue Dec 25, 2001 1:01 am
Location: Bellingham, WA

Re: pic's16F84

Post by L. Daniel Rosa » Fri May 14, 2004 4:17 pm

I use a different programmer, but when this happens to me it means that the computer and programmer are not communicating clearly. What worked for me was to increase the delay between bits (slow it down). Hope this helps.

Post Reply

Who is online

Users browsing this forum: No registered users and 4 guests