T&L Publications

thanx edd for the help..

thanx anyway , but this site seems to only let you buy a schematic , i just need to find someone that might know the value of the resistor i am looking for....

i was going by what dave said in the post before my last one.<p>[email protected]

any alarm company should have these also...i get them here locally also for about $5 a pop and they all use the same key also...they have about 5 different key cuts...same sw, just different cut keys..

i have a tv here..old magnavox
model : RR2540 A-104
chassis # 25S102-00DD
i need to find the value of s burnt resistor
location R-432 leads to the volt regulator..i know the regulator is shot too,,,due to dried up cap...
any info is apperciated...

ok, i tried as you suggested,, didn;t work,,, perhaps i need to change other connections? heres how i have all connected pin 1 = gnd. 330k = pin 1 & pin 2 10uf = pin2 & pin8 pin 3 output 100k = pin4 & pin8 0.47uf = pin4 & gnd. pin 5 = blank pin 6&7 tied pin8 B+ = 12v i hope you understand this... i ...

well only # i have here is to a..
diverse electronic services
nanticoke pa.<p>570-735-5053<p>i have a e-mail addy that never gets answered,,
[email protected]<p>and i get busy on the phone # all the time, as if it is off the hook...Grrrrr

bummer,, i just bought a model 1505 about 6 months ago too,,,
i guess customer service is a thing of the past..

thanx guys, i have brain overload / fart now...
learned a lot thanx

i have here a motor controller from a old electric scooter,, it is a "Curtis PMC" (curtis insturments inc.) MODEL 1208-139 i belive it still works, i contacted the company via e-mail 3-4 times asking about a connection diagram and the stats of this controller, i never got a reply yet...does anyone h...

a diagram whould be most appreciated...thanx

ok, heres part 2 of my idea,,,
how can i configure 555 timer to auto start timing as soon as power is applied..
a diagram whould be nice if possible...
i want it to auto start timing for about 5 seconds then end,untill power is re-applied..

i have hacked some of the units,,but theres so many different models out there now...one i used,, i added a SCR and a NE-2 neon bulb..when the charge was high enough it triggered the neon bulb,which fired the SCR..then flashed the strobe,,,this does it continously...only bad thing is...the unit draw...

ok, thanx,, so i am thinking on the right track then,,

hi all , i have seen these new 3rd brake light on newer cars here lately, the 3rd brake light will flash a few seconds then stay on...<p>i was thinking,, can this be done with a 556 timer and a relay? 1st part of timer acting as the flasher part,,and the 2nd one acting as low ( off ) untill certain ...