Sorry - forgot to attach this page. This is the primary side. I will be using 240 vac.
http://www.flickr.com/photos/22415457@N04/[/img]
Thanks
Search found 8 matches
- Thu Jan 03, 2008 6:31 pm
- Forum: General Discussion
- Topic: 3 phase welder
- Replies: 10
- Views: 4676
- Wed Jan 02, 2008 6:33 pm
- Forum: General Discussion
- Topic: 3 phase welder
- Replies: 10
- Views: 4676
- Wed Jan 02, 2008 5:14 pm
- Forum: General Discussion
- Topic: 3 phase welder
- Replies: 10
- Views: 4676
- Tue Jan 01, 2008 7:19 pm
- Forum: General Discussion
- Topic: 3 phase welder
- Replies: 10
- Views: 4676
- Tue Jan 01, 2008 4:28 pm
- Forum: General Discussion
- Topic: 3 phase welder
- Replies: 10
- Views: 4676
3 phase welder
I have a Hobart Model R400 3 phase welder (230 or 460 vac). Can I parallel all three transformers and run on single phase? Or can I just fed one transformer and run at reduced output? This is a 400 amp welder with a mag amp control. I don't need 400 amps, 150 would probably be plenty. Looks like I c...
- Tue Feb 24, 2004 5:34 pm
- Forum: General Discussion
- Topic: Automotive dual battery question
- Replies: 29
- Views: 11510
Re: Automotive dual battery question
The batteries are connected in parallel. The drivers side 4 ga. wire carries only the current from that battery. It connects to the passenger side battery. The 2/0 carries the current from both batteries. If both batteries are healthy, the current will be pretty close to the same from each battery.
- Mon Dec 01, 2003 8:08 pm
- Forum: General Discussion
- Topic: DELAY FOR SOLENOID
- Replies: 3
- Views: 2070
DELAY FOR SOLENOID
I have two identical 12 volt dc solenoids that draw about .5 amps coil current. I need to connect them so that one switch controls them both (coils in parallel). I need make sure one makes before the other. Will a choke provide the delay I want? If so, what size? This is an outside application, so I...
- Fri Jan 03, 2003 4:59 pm
- Forum: General Discussion
- Topic: Garage door opener safety sensors
- Replies: 13
- Views: 6187
Garage door opener safety sensors
How do those safety sensors work? They usually have two wires that connect to both units - transmitter and receiver. These wires must carry the power to the sensors and the signal back to the main unit. I don't want to disconnect them, I just want to understand how they work so I can trouble shoot -...