Search found 3 matches
Search found 3 matches • Page 1 of 1
The battery on my older camcorder died. The replacement battery listed by after market battery sellers is a nmhi type. The original battery was of nicad design. Will my old charger properly charge the nhmi design? The charger has an open circuit voltage of about 10V. The battery is rated at1.2A at 6...
- Sat Aug 20, 2005 6:57 pm
- Forum: General Discussion
- Topic: circuit board question
- Replies: 3
- Views: 985
This is a basic question. On the prototype circuit boards that have rows and columns of holes with unconnected copper pads on the bottom side, how are the circuits connected to the components. Are jumper wires run into the same hole as the component and both are soldered at the same time?