One-shot design needed
One-shot design needed
I need to design a simple circuit that will give me a 20us square pulse with variable amplitude (about 0V to 1V and at least 1mA). The event will be triggered by a button push.<p>I am familiar with variable pulse-width designs using the 555 but I am not sure how to vary the output amplitude without adding another stage like an op-amp to scale the signal.<p>At this point I am looking for suggestions for any similar design not just 555 based ones.<p>Chris
-
- Posts: 86
- Joined: Mon Jun 09, 2003 1:01 am
- Contact:
Re: One-shot design needed
The simplest idea I can think of is just a voltage divider. Two resistors in series between the output of the 555 and ground, take your output from the connection between the two resistors. The output voltage will be in proportion to the ratio of the two resistors, i.e. two 1k resistors will give you half voltage, ect.<p>Other ratios are redily creatable. If you use a pot, say 5k, with the wiper connected as your output, you can adjust it.<p>Good luck
Denny
Denny
-
- Posts: 26
- Joined: Thu Apr 17, 2003 1:01 am
- Contact:
Re: One-shot design needed
I don't have my magazine in front of me, but in this month's issue of Nuts & Volts, there is a section on transistor circuits. In it, there are a few oscillator circuits that uses discrete devices, I believe with two transistors, a couple of caps and a couple of resistors.<p>Or you might want to look into ring oscillators.
-
- Posts: 146
- Joined: Mon Jan 13, 2003 1:01 am
- Location: Chicago IL
- Contact:
Re: One-shot design needed
desterline has a good idea. You're already familiar with the 555; you might want to start with a standard 20 microsecond one-shot with a CMOS 555. Let's assume a regulated 5VDC supply. If you load the output pin with a 40K resistor in series with a 10K pot, you can adjust the wiper of the pot to give you pulses of 0 to 1V amplitude (the lightly loaded output of the CMOS 555 is practically equal to the power supply rails). If you then place that 0 to 1V signal as the input to a "rail-to-rail" op-amp configured as a voltage follower, you will have a low-impedance output. If you don't have a "rail-to-rail" op amp handy, you might want to try the LM6132 dual. It's 8 pins, and is available in the standard 8-pin DIP package. Don't use an LM358 -- it will accept your signal, but the rise time and fall time will probably be several microseconds. Happy hunting.<p>LM6132 Product Folder<p>[ July 03, 2003: Message edited by: Chris Foley ]</p>
Who is online
Users browsing this forum: No registered users and 3 guests