kronos flyer

Everything you ever wanted to know, and probably shouldn't, about building a (machine) death dealing monstrosity. Building tips, product reviews, event reports that might migrate into Servo; and comments/discussion/dissent about published articles.
Post Reply
Posts: 13
Joined: Tue Jul 16, 2013 12:27 pm

kronos flyer

Post by mrlich » Tue Jul 16, 2013 3:20 pm

:???: I have built the Kronos flyer with the Naza M V2 + GPS. My radio is a turnigy 9x and for the life of me I cannot get it to work with the Naza. My problem is the three position switch. When I get that to follow the guide, up is ATTI, MIDDLE IS GPS and down is Failsafe, the throttle then moves the U slider up and down the bar. This I believe is what is preventing me from starting the motors. The Naza boots up and goes through it test cycle and then goes into continuous yellow flashing, no pattern, just flashing. I think that somehow the Naza is starting in the failsafe position which accounts for the yellow flashing and no motor start. Can anyone help me with this? I have been adjusting this for two weeks with no success.

Posts: 90
Joined: Tue Dec 18, 2012 4:40 pm

Re: kronos flyer

Post by cae2100 » Wed Jul 17, 2013 1:10 am

are you doing this indoors? from what Ive read, the yellow LED will flash and not work until the gps module gets a full view of the sky and connects up to gps sattelite, the LED is an indicator that it' just waiting for a signal


Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests