RE: REFUSEABLE OLD PROJECT FROM SEPTEMBER 2009 N&V

Get help with your Nuts & Volts projects or Kits purchased from Nuts & Volts here.
Post Reply
jackwilker
Posts: 1
Joined: Wed Jan 19, 2011 1:29 pm
Contact:

RE: REFUSEABLE OLD PROJECT FROM SEPTEMBER 2009 N&V

Post by jackwilker »

REFUSEABLE PROJECT - SEPTEMBER 2009 uses a PIC.

Anyone out there build this project? Built one, does not work as advertised, looks like potential board layout issues on pin 18 and 2 of the uP. Essentially, software runs (goes to PRG, SELECT CURRENT works, AC / DC works, then..), but does not measure current. Relay is basically running at a 50% duty cycle (on - off), but does not indicate current on display when measuring across open fuse...Am I missing something here - already knew board layout does not allow direct relay connections, but have connected per schematic in original article...

Any ideas?

Regards,
Electroboticist
Post Reply

Who is online

Users browsing this forum: No registered users and 4 guests