Garage Door N&V 11/2010
Posted: Thu Dec 16, 2010 10:13 am
I love the concept, and think these could have many uses beyond garage doors.
So I bought a couple sets of the boards and chips, and have some issues I need help with:
1. The alarm is always On. I tied the three inputs (SW1-3) both High and Low and the alarm still sounds every time it loops through.
2. The Receiver depleated the batteries in 4 days with only 1 LED installed and with the alarm Off.
3. The Receiver has locked up several times with the Transmitter Inputs hard wired (no state change). Resetting the receiver by removing a battery solves problem for some period time, but then it happens again.
Unfortunately I am not an assembly programmer so am at a loss.
So I bought a couple sets of the boards and chips, and have some issues I need help with:
1. The alarm is always On. I tied the three inputs (SW1-3) both High and Low and the alarm still sounds every time it loops through.
2. The Receiver depleated the batteries in 4 days with only 1 LED installed and with the alarm Off.
3. The Receiver has locked up several times with the Transmitter Inputs hard wired (no state change). Resetting the receiver by removing a battery solves problem for some period time, but then it happens again.
Unfortunately I am not an assembly programmer so am at a loss.