My first post and have enjoyed the good info on other articles and projects.....thanks.
My question is after building this radiation kit is I have no high voltage output to the tube or speaker sounds.
I measured for voltage as stated in article using a 100 meg resistor and also touched the output with no shock felt.
The display shows all the functions as its supposed to except obviously not counting.
I replaced the zener to no effect and made sure it is the right voltage for the tube I am using.
Can someone give me an idea where to start replacing components?
I am not a total newbie but not sure what to try first.
Thanks in advance for any replies.
If there's an article in Nuts and Volts that you would like to discuss, this is the place!
1 post • Page 1 of 1
Users browsing this forum: No registered users and 1 guest