I'm trying to get into this little exotic project of connecting the old TI calculator to a PIC micro.
And as mentioned in the article the workings of the actual link is a bit of a challenge.
I have only a TI-89 not a TI-83. And a USB link cable. That means I can't use that mentioned terminal program and I don't get a virtual serial port on the PC to run a terminal program.
I got the PIC software going and can do test programs there.
On the TI I was using the SendChat command to send data to the port. But I don't get anything into the PIC and TI just comes up with communication error.
I wondered if there is a simple terminal program for the TI-89 that would just send out one byte at the time. I've tried a few terminal/chat programs but they all seem to do far too much for what I need.
Or is there another simple way to test the basic bit and byte transfer?
I'm planning to get the oscilloscope involved soon, but it's not available right now.
Thanks for your help.
If there's an article in Nuts and Volts that you would like to discuss, this is the place!
1 post • Page 1 of 1
Users browsing this forum: No registered users and 6 guests