ok if you could buy just one book (or website) that could help you just flash one led on and off
where would you start?
thanks...
g-
getting no where with pickit3
Re: getting no where with pickit3
You have the PicKit 3 and a board (which board?). You have either a compiler or assembler (assembler comes with MPLAB - you DO have MPLAB, don't you?).
If you got a board in a bundle with the PicKit 3, there are probably some samples around somewhere.
What device are you using (the PIC itself)?
If you answer some of those questions, I will talk you through and get you up and running.
Hope it helps,
Kevin
If you got a board in a bundle with the PicKit 3, there are probably some samples around somewhere.
What device are you using (the PIC itself)?
If you answer some of those questions, I will talk you through and get you up and running.
Hope it helps,
Kevin
Re: getting no where with pickit3
hey buddy
i have an icsp14 adapter from www.j1sys.com that i got on ebay
and yes the pickit3 came with mplab ide v8.46
the chip i am using is a 12f683
thanks in advance
g-
i have an icsp14 adapter from www.j1sys.com that i got on ebay
and yes the pickit3 came with mplab ide v8.46
the chip i am using is a 12f683
thanks in advance
g-
Re: getting no where with pickit3
Sorry for the slow response - I am bogged down with homework
Anyway, you should be able to find asm code that will blink an LED for the part you have. Have you been in MPLAB and set the programmer to PicKit3 and see the device connected? If you set the programmer to PicKit3 (in MPLAB), it will look to see what device, if any, is connected to the PicKit3. Does the device show up?
What is the exact problem you are having?
Anyway, you should be able to find asm code that will blink an LED for the part you have. Have you been in MPLAB and set the programmer to PicKit3 and see the device connected? If you set the programmer to PicKit3 (in MPLAB), it will look to see what device, if any, is connected to the PicKit3. Does the device show up?
What is the exact problem you are having?
Re: getting no where with pickit3
i got the pickit3 talking to the 12f683
just trying to get a handle on the asymble langauge
i would love it if i could just flash an led or two...
im not sure how to make the pins out puts and how to tell them high and low for x amount of time
ps hows school going?
just trying to get a handle on the asymble langauge
i would love it if i could just flash an led or two...
im not sure how to make the pins out puts and how to tell them high and low for x amount of time
ps hows school going?
Who is online
Users browsing this forum: No registered users and 11 guests