T&L Publications

NSM is a german JB..as you may have seen from the manual and other parts of the JB..
most of the caps on the amp board should still be ok,,,usually the power supply is the suspect...
humm and buzz etc...
good luck

what part of this JB do you need the cap kit for ?
the amp or the computer? if there is one?
i work in coin ind. and usually if its the amp you just rework it,, there are no kits available,,
if its the amp,, usually just re-cap the powersupply of the amp..
good luck

hey i found something to work,,, microwave dioads !
125MA @ 25kv !<p>should have thought of that earlier..lol i thought they were less than that,, but not so... thanx a lot guys...

Ray Samples
803 W. Mountain dr.
fayetteville NC 28306<p>maybe i have something to trade, who knows,, or i can send a check for the postage,, which ever you need,,

cool, i'd be interested in playing with about 2 of them,, <p>how can i get them? and how much $? :p

i already have this set up,, and theres no options for that,, this is the only out door high brightness flourascent light i found,,
thanx again

do you mean the ignitor circuit is a electronic ignition ? or is it using breaker points?
if useing electronic ignition then more likely the modual is bad,, is it so expensive to replace?<p>also does the unit use any battery or is it self made power? ( magneeto )?

sorry the light is 120vac...Hmmm thanks anyway

dudes ! theres already commercial ones made for cheap.. they are in many shops / stores., you know,,, the take a # and wait till they call you,, and usually they have a digital display on the wall so you can see your # is up,, most baskin robbins here have them,, take a look in your local area,, may...

he said it was and older set, older than CTC series,, i have seen the olderones as such different pre-fixes,, i will search for you, and give a reply back soon

i seen at 3 different museums that they used a HV DC supply to charge the belt,, maybe theres 2 different ways to make the charge...?i am wanting to use the inner circle cut out of a auto innertube,, hoping that may work,,, always looking for input...<p>also looking for a complete diagram of a whimh...

thanx bodgy , i have looked at flyback transformers in tv set,, but the dioads are inside the transformer,,<p>also microwave dioads are too small to handle 15kv,,<p>and the zappers are no good either,,<p>maybe i can series the microwave dioads..but i must find out how much current they can take

is it a must that the HV going to the belt of this machine, must be DC ?<p>and if so, where can i find such HV rectifiers ?<p>i am about 1/2 built in mine,,and i will be using a 15kv / 30ma transformer
where could i find such rectifiers ,, new / used

PS > the light i am using here with this project is a... Lights of America , model # 9266
gives a lot of light,, approx 2,580 lumens for about 65 watts,, very efficient !

i use what i have, because its very low current as opposed to halogen lamps, true they are very bright, but draw a lot of current too,, the design i have will give over 1 week of service with no solar charging ,lights are on as long as a 1/2 hr at times..i am using a 20AH battery,, with halogens the...